How to Clean Batch Feed Garbage Disposal Models
Batch Feed Models sink stopper must be locked before operation, then you cannot waste added as the unit runs.
Remove the sink stopper and turn on a medium flow of cold water. (Cold water will keep food waste and fast solid so they can be flushed down the drain.)
Scrape in food waste.
Insert the stopper to start the Garbage Disposal, (Food Waste Disposer and Garburator).
One of the two small slots in the stopper base must line up with the switch plunger inside the neck of the Garbage Disposal, (Food Waste Disposer and Garburator).
Note: The oval shaped handle aligns with the 2 small slots in the stopper.
Push down firmly to start.
Run the garburator for 25 seconds after shredding stops. This assures that all waste is thoroughly flushed through the trap and drain.
Lift the stopper to shut the disposer off.
To fill the sink, insert the stopper so that the largest slot lines up with the switch plunger. The stopper can now be pushed down to seal the sink without starting the Garbage Disposal, (Food Waste Disposer and Garburator). When the medium-sized slot in the stopper base is lined up with the switch plunger, water can drain, but tableware, etc., cannot be accidentally dropped into the Garbage Disposal, (Food Waste Disposer and Garburator).